AllChem Logo

русский















Diagnosing of malfunctions

In this chapter the description of checks which are necessary for making at occurrence of malfunctions is made. It is necessary to pay special attention to the section devoted to function of self-diagnostics, allowing considerably to simplify search and elimination of malfunctions.

Function of self-diagnosing

The automatic temperature regulator possesses function of own diagnosing. Translate the switch of ignition in condition ON and include an automatic temperature regulator. Having established temperature 18°С, , whether check the temperature raises at rotation of the handle of installation of temperature up to 32°С. After installation of the certain temperature if simultaneously to press buttons AUTO and OFF and to wait about 1 minute the board, showing malfunctions of system, lights up, adjusting on breakage in circuits of a potentiometer, short circuit, blocking of the engine. The above-stated results of the decision at deenergizing ignition disappear from memory, and concerning abnormal gauges, having entered replacing values, continue regulation.

1 – MODE button
2 – compressor ON button
3 – fan OFF button

 

  Designation sections Defect place Defect reason Replaced value
 A  Thermode of internal air Breakage or short circuit 25°C
B Thermode of external air Breakage or short circuit 10°C
C Solar gauge Breakage or short circuit 0 kcal/m2·ч
D HEATER CORE thermode Breakage or short circuit 80°C
E Thermode behind evaporator Breakage or short circuit -1°C
Potentiometer A/M GND short circuit  
F A/C
ON
Electric motor A/M Shut  
 
Mode potentiometer GND short circuit  
G A/C
OFF
Mode electric motor Shut  

 

The thermode of internal air is located in the block of an automatic temperature regulator and if this display bulb replace the block of an automatic temperature regulator lights up.

After the termination of works on repair, after having included function of self-diagnosing they check whether other defects have appeared.